pt-summary better info about bonding interfaces
From bug 1177037:
For example:
# cat /proc/net/
Ethernet Channel Bonding Driver: v3.6.0 (September 26, 2009)
Bonding Mode: fault-tolerance (active-backup)
Primary Slave: None
Currently Active Slave: eth0
MII Status: up
MII Polling Interval (ms): 100
Up Delay (ms): 0
Down Delay (ms): 0
Slave Interface: eth0
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: b4:b5:2f:5d:34:94
Slave queue ID: 0
Slave Interface: eth1
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: b4:b5:2f:5d:34:95
Slave queue ID: 0
However, all that pt-summary outputs is:
# Network Devices #######
Device Speed Duplex
========= ========= =========
bond0
eth0 1000Mb/s Full
eth1 1000Mb/s Full
Would like info in the summary on:
- bonding type (fault-tolerant in this case)
- slave status (eth0 and eth1's status in the bonding), which is active, etc.
Blueprint information
- Status:
- Not started
- Approver:
- None
- Priority:
- Undefined
- Drafter:
- None
- Direction:
- Needs approval
- Assignee:
- None
- Definition:
- New
- Series goal:
- None
- Implementation:
- Unknown
- Milestone target:
- None
- Started by
- Completed by