cut, paste and delete behavior in schematics

cut and paste of things from one schematic sheet to another is non logical and complicated

once you selected something it would be so nice if schematics not started to move around this but just kept it as selected.
the you can decide what to do a copy, cut, delete, move, flip etc...
.
once that is done you should be able to replicate by more paste (as many as you like in series) , even move to other sheets.

when you do the paste you should be able to right click once more and select
(x) copy netnames
(x) copy refdes

if you decide to move a part of your schematic to another sheet today you loose all your refdes and netnames
and those may already be on pcb routed and finished.

not so funny then to get refdes and netnames messed up.

today you need to toggle between the original and the copy and make sure you get all your refdes and netnames correct, manually.

then delete the original.

its a pain.

also since you cannot do cut, you end up with the likely hood of not remember to delete the old block since you can only do save block

also please once you selected a region of things please make the delete button work, very tedious to have to right clock delete copy.

and another thing, when you package componentes you end up at another schematics page than the one you where in from the beginning.